IntensaFIRE Controller Mods for Xbox 360 and PlayStation 3

Fastest & Easiest Xbox 360 and PlayStation 3 Controller Mods

I've got the board soldered in, i've taken it off and put it back on as well as made sure none of the three right trigger points touched another via solder.

The right trigger works, just wont rapid fire regardless of mode. The left trigger will when on mode two, but no matter what mode i put it on the right trigger operates as off the intensafire board was never installed.

I've searched, i've re-installed it and ive done just about everything else I can think of to get this to work with no success. 

Any suggestions?

Tags: right, soldered, trigger

Views: 7

Reply to This

Replies to This Discussion

(xbox 360 250gb (slim) wireless controller)
There's the possibility that the chip on the intensafire overheated during your soldering process, especially during the removal of it the first time if you didn't use the proper tools to remove the solder.

Reply to Discussion

RSS

Xbox 360 IntensaFIRE

© 2012   Created by Team IntensaFIRE.   Powered by

Badges  |  Report an Issue  |  Terms of Service