IntensaFIRE Controller Mods for Xbox 360 and PlayStation 3
Fastest & Easiest Xbox 360 and PlayStation 3 Controller Mods
intensafire not working?of
today i installed the mod and i have a couple problems.
1. it works for 20 minutes then stops(sync button doesnt work), then starts again and then stops and...
2.my SELECT button doesnt work even when the sync button is
3.when the sync button does work it doesnt change modes by pressing the sync button, i actually have to hold it and once my controller re-syncs with my xbox THEN it changes modes.
could it be cuz my connection to the sync buttton isnt good? or cuz the glue only dried for 30 minutes before i retried the sync button
(btw i have a matrix controller)
would it help if i posted a pic?
Views: 52
Replies to This Discussion
-
Permalink Reply by Mike Yabz on -
all the problems listed above have been fixed but now i have new ones.
first mode 3 didnt work, then mode 2(dual mode) emptied all my mags the second i choose it even if im not holding the trigger and then everything just screwed up(i turn on my controller and it just cycles through every mode endlessly? i tried googling these problems but found nothing. help?
-
Permalink Reply by Alex S on
-
It is probably your glue work. I am suspecting that is the cause of my problem, but you should make sure you are not connecting any of the points on the board, especially the Right Trigger points.
-
Permalink Reply by Patrick Mason on
-
All the answers are here on the forums. Anyway, you messed up reglueing. If you have access to a soldering iron, I would suggest soldering. Get some nail polish remover, remove all the glue, then solder. Or you could try reglueing a third time. Make sure to clean all the previous glue off.
© 2012 Created by Team IntensaFIRE.
Powered by
