IntensaFIRE Controller Mods for Xbox 360 and PlayStation 3
Fastest & Easiest Xbox 360 and PlayStation 3 Controller Mods
Intensafire not going so well
Whenever i use the intensafire it'll work for the first few minutes, but then any time i press the right trigger the intensaifre turns off! anyone got any tips?
Views: 4
Replies to This Discussion
-
Permalink Reply by kEEf on -
you probably used too much glue and connected points under the flex board. You can remove the glue with nail polish remover and a que tip. Remove the flex board, remove glue from it and from the controller board beneath. Replace the flex board and solder the points instead of using the glue.
Or send it in here and pay to have it done for you.
Remember, you can FLEX/ bend the board so it lays in direct contact with the points before taping it down. Make sure you tape it down. I actually left a little piece of tape near the sync point because it wasn't in the way and it was an iffy spot, it had popped up on me once after removing the tape.
© 2012 Created by Team IntensaFIRE.
Powered by
