Doesn't work for me

I have the 2.0 installed with glue after waiting overnight, turned it on and it was ok, i hit the synch button the red mode light came on and when i got to setting four it started flashing and the red 3 and 4 lights were blinking and the synch light started rotating around on the controler and then the four light on the controler started flashing yelllow Disconnected the board using nail polish remover cleaned all conductive glue off of the board and let dry, looked up on the forum and people were having issues with glue so they said solder. I soldered the board in and now when I turn the control on the lights are doing the exact same thing...I removed the board and the controler is working fine now. So it's something screwed on the intensafire. Can anyone help me?

Matrix board

▶ Reply to This

Replies to This Discussion

Permalink Reply by IntensaFIRE.com Editor on October 3, 2011 at 8:34am

Not sure what might cause the issue you described, but you could check out our Xbox 360 Soldering Tutorial to see if there is any info there that might help you determine the problem:

http://www.intensafire.com/forum/topics/xbox-360-soldering-tutorial

▶ Reply

Permalink Reply by poolgodjd on January 23, 2012 at 12:38pm

If you dident trim shell you broke the board it is repairable but can't be done with glue must be solder can he'll you if needed moon.id@gmail.com

Doesn't work for me

Replies to This Discussion

Xbox 360 IntensaFIRE